120W Mini ITX Internal Power Supply 20-pin Mini-ITX LR1204-120W12VDC
$24.99 USD
About this product
INPUT REQUIRED:
INPUT VOLTAGE RANGE：11.4VDC—12.6VDC
INCOMING CURRENT RANGE：12.0A Max @11.4VDC
INPUT SURGING CURRENT：12.0Vmax@12VDC
WORK EFFICIENCY：≥85%
OCP： output shut down when output current reaches the peak point.
Short-circuit protection：output shut down when short-circuit.
Environment description:
Working temperature/humidity 15℃ to 35℃ / 45%-75%
Reposition temperature//humidity -40℃ to +70℃/ 10%-90%
Atmospheric pressure 86Kpa—106Kpa
Other parameters:
Working frequency：Icbuilt-in oscillator（250-350）kHz@Vcc=12V
Feedback reference voltage：0.8V±2%@12VDC
6inch SATA 15pin Female to Molex 4pin Male Power Adapter
$1.99 USD
About this product
The Serial ATA standard provides for the adoption of a new 15-pin drive power connector, replacing the ubiquitous 4-pin Molex connector. However, existing system cases and power supplies may have an insufficient number of SATA power connectors, while still retaining the older Molex connectors.
This 6" adapter cable plugs into a 4-pin Molex power plug and provides a single 15-pin SATA power connector.
Warning! The Molex connector provides only 5 and 12 VDC power. While many SATA drives only require these power levels, some require the additional 3.3 VDC power provided for in the SATA specification. Make sure your drive does not require 3.3 VDC before purchasing this adapter cable.
Input 100--240V, 50-60Hz (worldwide use)
Output is 12V 5A, 60 Watts.
Power Jack dimensions:
Inner diameter - 2.5mm
Outer diameter - 5.5mm
1. INPUT CHARACTERISTICS
1.1 Input Voltage:
Nominal Voltage:100-240Vac
VariationRange:90-264Vac
1.2 Input Frequency:
Nominal Frequency:50/60Hz
Variation Frequency:47-63Hz
1.3 Input Current:
1Arms max At any input voltage and rated, DC output rated load.
1.4 Inrush Current:
30Amps Max. Cold start at 240Vac input, with rated load and 25Žambient.
1.5 Ac Leakage Current:
0.25mA Max At 240Vac input.
2AOUTPUT CHARACTERISTICSF
2.1 Power Output;
Voltage Min. Load Max. Load Peak Output Power
+12Vdc 0A 5.0A 18A 60W
2.2 Combined Load/Line Regulation:
Voltage Min. Voltage Max. Voltage Line Regulation Load Regulation
+12Vdc 11.5V 12.5V }5% }5%
2.3 Ripple And Noise:
The ripple and noise are as follows when measure with Max. Bandwidth of 20MHz and Parallel 47uF/0.1uF,crossed connected at testing point.
Voltage Ripple And Noise(Max.)
+12Vdc 120mVp-p
2.4 Turn On Delay Time:
2 second Max. At 115Vac input and output Max. Load.
2.5 Rise Time:
40mS Max. At 115Vac input and output Max. Load.
2.6 Hold Up Time:
5mS Min. At 115Vac input and output Max. Load.
2.7 Efficiency:
80%Min.At 100Vac input and output Max. Load.
83%Min.At 240Vac input and output Max. Load.
2.8 Overshoot:
15%Max.When power supply at turn on or turn off.
Standard round mouth output interface: 2.5mm inner diameters, 5.5mm outer diameter; 12V output voltage, 84W output power
Input voltage: 90-260Vac
Overcurrent protection, overvoltage protection and overheat protection etc.
1. Description:
This specification applies to the switching power whose model no. is LR120070
2. INPUT:
Input voltage range: 100Vac – 240Vac
Rated voltage range: 100Vac – 240Vac
Input frequency range: 47Hz – 63Hz
Rated input frequency: 50Hz/60Hz
Input current: 1.7A max. at full load
Inrush current(cold start): 20Atyp peak,220Vac Input
3. OUTPUT:
Output Voltage (Vdc): 12±0.5V
Output Voltage Limit (Vdc): 11.5- 12.5
Output Ripple & Noise (mV): ≤120
Output Current (A): 10.3
Notes: Ripple Voltage is measured with an oscilloscope with bandwidth 20MHz. A 10uF
E-cap and 0.1uF ceramic-cap shall be connected to the connector in parallel.
4. Protection:
4. 1 Short circuit protection:
The power supply will be auto-recovered after circuit faults remove.
4. 2 Over current protection:
The power supply will be auto-recovered after short circuit faults remove.
5. Environment Requirement:
5. 1 Operating Temperature: 0℃ - 40℃, Full load, Normal operation.
5. 2 Storage Temperature : -40℃ - 85℃(With package)
5. 3 Relative Humidity: 5%(0℃) ~ 95%(40℃),72Hrs,Full load, Normal operating.
6. Safety and EMI Requirement:
Meets the Limits:
- FCC class B rules
- EN55022 class B rules
7. The power supply size: 141±0.30mm*60±0.30mm*32±0.30mm(L*W*H)
8. Weight: The weight of the power supply shall be about 0.35Kg.
19V 90W AC DC Adapter For Intel Thin Mini ITX Motherboard DQ77KB DH61AG SSA-0901-19
$19.99 USD
About this product
Compatible with:
ASUS PRIME H310T/CSM LGA 1151 (300 Series) Intel H310
INTEL BLKDQ77KB THIN MINI ITX MOTHERBOARD LGA1155
Intel Desktop Board DH61AG Thin Mini-ITX
Features:
Smart device surge protection for over voltage, temperature and short circuit protection
Strong built for heavy duty and long usage performance
SA CE CCC RoHS certified equipment
Technical Specifications:
AC input voltage: 100-240VAC
Input frequency: 47-63Hz
AC inrush current(max.): 20A/230V
4Line regulation (full load): ±0.5%
Peak- to -peak ripple: <100MV
Working temperature: 0-35℃-100%,50℃-70% load
Setup rise hold up time: 100ms,50ms,20ms-240VAC input
Over voltage protection: 115%-135% rated output voltage
Withstand voltage: I/P-O/P 3Kvac,1 minute
Over load protection: 115%-135% fold back current limiting, Auto-recovery
